RomRaider

Please could i kindly have a def file for the following hex file ?
Ps is this rom the best to use on a 2002 subaru legacy 5spd Manual transmission slight free flow exhaust, Decat and standard air intake standard boost. running 92 octane ?
Please help need a def file for ecuflash and Romraider or romraider only would be great!!!! thankyou guys great work hope soon i can contribute also

Ticket opened: http://trac2.assembla.com/romraider/ticket/105

Thankyou Mr Dshcutlz how long doe sit typically take for a definition file to be greated for a ecu rom file ? this is a new to me so not sure aabout time frames etc. i will wait patientntly till something comes up but a bit anxious

I'm sorry to say it may take a long time. I'm not aware of anyone working on definitions for the older 16bit ECU's. I've never looked at one myself.

any news?

Have someone the A4SHC00G definition? I think they are similar with last one.

Just modify turbo setup to the single turbo and upload any wrx or sti 2001-2002 map)

it's already "дико колхозный" single turbo setup without avcs with boost controller. Are you sure that will work? The legacy ecu logic of works more difficult than wrx or sti.

Sample for the ignition (same for other parameters with dependency on IAS valve):
Main Ignition Map - IAS Closed
Main Ignition Map - IAS Open
Ignition Correction Map - IAS Closed
Ignition Correction Map - IAS Open

May be this file http://www.xtremeracingtuning.com/others/A4SHC01G.xml will help. I opened some significant maps for IAS opened, but not sure that will work properly. Boost will managed by boost controller.

<table name="Primary Open Loop Fueling" address="2954D">
<table name="X" address="2952C" elements="16" />
<table name="Y" address="29507" elements="18" />
</table>

<table name="Base Timing" address="2A0D9">
<table name="X" address="2A0B7" elements="16" />
<table name="Y" address="2A092" elements="18" />
</table>

<table name="Timing Advance (Maximum)" address="2A8AB">
<table name="X" address="2A889" elements="16" />
<table name="Y" address="2A864" elements="18" />
</table>

<table name="Injector Latency" address="28A6C" />
<table name="Injector Flow Scaling" address="28A64" />

== Homebrew downgraded

has any one actually done the single turbo conversion ?
Maybe its better to get a wiring loom and ecu and sensors and then convert to make it run as a single turbo .
Let me know maybe i will go down this route .

Cheers
Adam

Getting my head around 16bit disassembly - this rom is my first guinea pig. About half way through already.

Good hearing form you!

That means it is almost done - the second part is RAM (0x20000:0x27FFF) and calibration (0x28000:0x2FFFF) area's...

Do you like to analize bootloader and ETC code I have uploaded ?

viewtopic.php?f=25&t=8252

Thanks for the vote of confidence Sasha - I'll definitely have a peek - but I'm still finding my feet in the 6816 roms, much slower going than what I'm used to in the 32bit roms!

I have the bulk of the rom disassembled (there are a couple of addresses I have not yet figured out, will get there, but 95% done). Busy inserting the addresses into an Ecuflash definition, will post up once completed.