RomRaider

D2UH001M
ADM Liberty 3.0R Manual

The current definitions don't have an AVCS map or a lift map. Would love to see these added.

Also is it 100% safe to change the values of the rows & columns on the maps? For example, the closed loop fuel maps start at 3200RPM. Does that mean it currently just uses the 3200rpm value for all revs below 3200? Is it safe for me to change the values on the left to start at about 1800rpm through to the same 6800rpm. I want to make it run richer than 14.7:1 below 3200.

Is it safe... that we'll know once you do it.

But to answer the questions, yes it uses the 3200 value for anything below that and yes you can change the row/column values to whatever you feel you need. As above the left/right/top/bottom column and rows are the bounds of the table and anything outside of those bounds will use the value at the edge of the table.

The only thing you can not do is change the size of the table in RR.

Sweet. 14.7:1 target AFR is on the lean side so I'd like to keep it at about 13.2:1 down to about 2800rpm and about 13.8:1 below that under full load.

So is there anyone who can update the definition with an AVCS and lift map? Do I need to upload the ROM?

Have you logged that? I mean 14.7 under load at low RPM. If not then I'd suggest you do as there are, or maybe tables undefined that compensate and lower the AFR. Open Loop transition for one, once you hit a certain threshold you switch from the CL table to the OL table for fuelling.

I'm getting an Innovate LC1 then I'll know for sure. The bottom target value on the primary open loop fuel table, even at full load, is 14.7 @ 3200.