RomRaider

I've been using Romraider for about a week now turning my car. Just this morning I flashed a new map to my car and wanted to do a log. It's worked fine since, but for some reason it was showing around 3.9-5.0 instead of what my wideband gauge read (14.7). I closed romraider, reopened it, same thing. I shut off the car, shut off the laptop, disconnected the terminator plug and out plug on the wideband sensor, reconnected them, restarted car, turned on the laptop... Same thing.

I closed romraider and opened logworks. Sure enough reads 14.6-14.8 at idle there. So I know the signal is correct. I believe Romraider is chopping off the first digit for some reason so it's reading 4.7 instead of 14.7.

Any ideas? It's the LC-1. I just installed Romraider on my pc 2 weeks ago with all the latest definitions, so I should have the newest version. It was working fine too:/

The LC-1 probably forgot the AFR multiplier value. Reset it with LM programmer.

Man you were right. I had no idea what you were talking about at first but I read through the manual. I've never even used the programmer utility that came with it. No idea how it got set to something else. It worked fine for a week before changing somehow. Thank you!