I was wondering if anyone would happen to know which additive table is used in non-cruise mode. I know there is a blending and multipliers for each additive table but I'm not sure which one is used in non-cruise.
I am guessing that Additive B is the one for non-cruise, in which case, assuming stock values and that KCA = ((KCA primary max + KCA additive A) * IAM) + KCA additive B, then total KCA should look like:
Does that make sense? Those are some awfully high KCA values, though the 09 WRX has a max KCA of 7.38 in some cells, so I guess it isn't too crazy.
The reason I am trying to figure this out is because I want to know the total ignition timing for some of the stock load areas. I think my current map could be a bit more optimized in these areas and I'd like to start with stock values. I'd also like to 0 out the additive tables and add that timing to the primary max tables (so I don't lose timing.) I just need to know which additive table is active when in non-cruise.
I assume only one additive table is active at any given time.
Thank you in advance.