RomRaider

Standard warnings. You will have to change the MAF, injectors and latency to fit yours.
My Mods + mods listed in sig.
Large tmic
12 lbs flywheel
Cat less up pipe
565 pinks
Cobb SF intake
3" samco turbo inlet hose
3"catless tbe
3/16 mod
Set for 20psi
11.1 afr
This setup works really well for me. As always this is just a starting point for those with a VF22. My car does have a slight surge at top end, which I believe is due to no helper spring on the waste gate. So it blows open (common for the vf 22) Feel free to leave positive input and suggestions. I took my map and copied it over to a stock rom as I have an accessport and street tuner. So you may have to double check the obdii defeat codes, as I did not have time to do this.

(UPDATE)
I updated this map after some more tuning. This map has launch control as well. The surge is gone on the top end. I also change the CL/OL transition to factory for better fuel economy. I richend the top end with the maf scale as I was leaning out on the top end. You will have to adjust this. I worked on the timing as well and rescaled the x and y-axis to better match the turbo. I was also able to raise the boost to 21 psi with good results. I took the tee between the compressor and WG out and replaced it with one that has a 3/16 for the line that goes to the EBC. Another words I run the stock size line from the compressor and WG to the tee. Then I run a 3/16 line straight to the EBC. Again this is just a starter point. Use at your own risk
Any Constructive input is welcome.
Jeff