RomRaider

K&N Air Filter.
Decated up pipe.
3 inch decated down pipe.
Milltek-UK cat., back exzo.
STI TMIC.
STI Pink Inj.
Walbro fuel bump.
LC @ ~ 5100 rpm.
Profec B Spec2 EBC @~ 1.3 bar.
Fuel RON 97.
Turbo: IHI VF35.
TGV delete.
Pulley change.
Day time temp: 32 - 35 degC.

Update: 05/02/2010.

Hv to take out this map.
Reason: Some jacka$$ in my area used this as their so call "pro-map" & resale for money (no map been change).

hmmm... download 21 times, but no words of wisdom?? there meust be some thing to said right??

Are you looking for words of wisdom ?

In which case asking a question would help

OK, any one feel a flat spot or power loss in the rev band?

10Q.

I cant feel one but I can definitely see one by looking at the timing table in 3d.

Big dip in timing at 4400 most of the way up the load range.

3D map view isnt one of romraider's strong points. ECUFlash is much easier to see the maps in 3d and smooth them out.

You need to concentrate on getting the maps smooth and logical.

OK. 10Q... will try to adjust that @ 4400 rpm.

sorry to ask what is "logical" mean here??

There should be a progressive increase in timing with revs to allow for the extra time needed for the flame front to travel and burn the mixture. Therefore each increase in rpm should have an increase in timing. The point at 4400 on your maps actually goes down. Maybe that was to fix a det issue but the correct way to do it would to be smooth the surrounding cells to still allow this logical increase.

The timing should also logically decrease with increased load.

This is a screen dump of my base timing map:



You will see a natural and smooth trend in all directions.

This map isnt finished but you can see a difference between that and yours shown below:

OIC... that's call logical. Will do that later in my free time. Also mosto fht etime I do it on the road test not on a Dyno machine.

10Q again!!

LC @ ~ 5100 rpm

what does LC mean?

Launch Control

young,
U r here too?? So which country r u in?

birmingham west midlands

W/ some remap of the rom this is the best I can do on the power/torque output w/ a IHI VF35 turbo(used).

dynamix, is it possible to re-post your pictures on base timing map comparisons? the pix are gone..

updated w/ a VF35 map.